Code: 5629

A premium-grade, high-solids, low-viscosity polyurethane primer for metal. Features:

• Easy to sand and powders easily, making it ideal for hand sanding.
• High solids, low viscosity  provides superior build with minimal thinning
• Superior chemical and moisture resistance
• Fast drying properties ensure early recoat and faster shipping & handling times

Specifications:

Colour : White, black tintedFinish : N/ABuild : Very HighSandability : ExcellentVertical Hold Up : ExcellentSolvent Resistance : ExcellentWater Resistance : ExcellentLevelling & Flow : ExcellentSink Back : MinimalCoverage : 6 -7m2 per litre at 150 micron wet film build. This is dependent on the application equipment / gun set up and the article being coatedDry Time : Refer to Technical Data SheetClean Up : Clean all equipment using MIROSOL 1222 ThinnerPackaging : 4 -16L

To View Tech Data Sheet and Safety Data Sheet: Register To View

Application:

Mixing Ratio (by volume) : 3 parts 5629 Part A + 1 part 5747 Part B (3A:1B)Pot Life : 2 hours at 25°C (refer to datasheet)Thinning : Thin up to 20% with MIROSOL 1217 (Fast), 1265 (Medium), 1266 (Slow), 1218 (Ultra Slow)

Suction Gun - Use 1.5 to 2mm (59-79 thou) orifice with 350-400kpa (50-55 psi).Pressure Pot - Use 1.5 to 2mm (59-79 thou) orifice with pressure pot air-cap. Gun pressure 350-400kpa (50-55 psi) and a pot pressure of 45kpa (6 psi) max.Airless Spray - Use 0.23 to 0.33mm (9-13 thou) orifice, 15cm fan (dependent on job) with regulated pump pressure of 350-400kpa (50-55 psi).Air Mix Guns - Settings similar to airless spray with the air-assisted regulator pressure at 70-90kpa (10-15psi).

Where To Use: Interior & exterior applications suitable for some automotive plastic & plastic parts, metal structural frames, machinery, caravans & earthmoving equipment.