MIROPOL PE Polyester Coatings

Mirotone’s range of polyester undercoats provide an ideal base for top coating with MIROTHANE PU polyurethane topcoats. Whether you are looking for an easy to sand undercoat or a premium, high build polyester undercoat to achieve an exceptional high gloss finish, Mirotone has the product you need. Typical applications include: Interior MDF & particleboard, internal doors, kitchen & bathroom cabinets, commercial joinery / wall panelling and domestic furniture.

 

MIROPOL PE 5007 High Gloss Clear Topcoat

MIROPOL PE 5007 High Gloss Clear Topcoat-image

Code: 5007

A high build, isocyanate free, two pack polyester, clear coating. MIROPOL 5007 Clear has a very hard, high gloss clear topcoat finish to provide a “glass like” appearance. Features:

  • High Build
  • Very High Gloss
  • MIROPOL 5007 Clear can be applied to both natural timber substrates or foil covered MDF board. For interior use only.

Specifications:

Colour : ClearFinish : Full GlossBuild : ExcellentSandability : GoodVertical Hold Up : GoodSolvent Resistance : ExcellentWater Resistance : ExcellentLevelling & Flow : ExcellentSink Back : MinimalCoverage : 8m2 per litre at 100-150 micron wet film build. This is dependent on the application equipment / gun set up and the article being coatedDry Time : Refer to Technical Data SheetClean Up : Clean all equipment using MIROSOL 1215 ThinnerPackaging : 20L

To View Tech Data Sheet and Safety Data Sheet: Register To View

Application:

Mixing Ratio (by volume) : Mix 1 part by volume MIROPOL 5007 Clear Topcoat to 1 part by volume MIROPOL 5007 "B" Solution and stir thoroughly.Pot Life: 2-3 hours. Mix only small quantities at any one time..Thinning : MIROPOL 5007 Clear is supplied ready for use (RFU). If required use MIROSOL 1234 Ultra Fast Thinner sparingly.

Suction Gun - Use 1.5 to 2mm (59-79 thou) orifice with 350-400kpa (50-55 psi).Pressure Pot - Use 1.5 to 2mm (59-79 thou) orifice with pressure pot air-cap. Gun pressure 350-400kpa (50-55 psi) and a pot pressure of 45kpa (6 psi) max.Airless Spray - Use 0.23 to 0.33mm (9-13 thou) orifice, 15cm fan (dependent on job) with regulated pump pressure of 350-400kpa (50-55 psi).Air Mix Guns - Settings similar to airless spray with the air-assisted regulator pressure at 70-90kpa (10-15psi).

Where To Use: Interior use. Solid and veneer timber fixtures and furniture. Restaurant, bar, and hotel furniture. Piano's. Funeral caskets and shop fittings

 

>