Javascript seems to be disabled in your browser.You must have JavaScript enabled in your browser to utilize the functionality of this website.
+64 800 346 474
CLICK HERE FOR AU SITE
Colour : Black Solvent Resistance : Fair Water Resistance : Fair Levelling & Flow : Good Sink Back : Minimal Coverage : 7-10m2 per litre at 150 micron wet film build. This is dependent on the application equipment / gun set up and the article being coated Dry Time : Refer to Technical Data Sheet Clean Up : Clean all equipment using MIROSOL 1286 Thinner
Data Sheet
Safety Data Sheets
Thinning : Thin 5 to 15% with MIROSOL 1234 or 1286 Fast or 1294 Medium Thinner.
Suction Gun - Use 1.5 to 2mm (59-79 thou) orifice with 350-400kpa (50-55 psi). Pressure Pot - Use 1.5 to 2mm (59-79 thou) orifice with pressure pot air-cap. Gun pressure 350-400kpa (50-55 psi) and a pot pressure of 45kpa (6 psi) max. Airless Spray - Use 0.23 to 0.33mm (9-13 thou) orifice, 15cm fan (dependent on job) with regulated pump pressure of 350-400kpa (50-55 psi). Air Mix Guns - Settings similar to airless spray with the air-assisted regulator pressure at 70-90kpa (10-15psi).
General metal furnishings, office furniture, filing cabinets, hand rails, gates, trusses, bull bars, two bars, earth moving and materials handling, shot blast holding primer, plant & machinery equipment and tanks.