MIROBILD AC 3750 Pigmented Topcoat

• High build, ehances the finished appearance by providing maximum build with the minimum number of coats
• Bright white and low yellowing which minimises discolouration of light coloured coatings
• Excess MIROBILD AC 3750 topcoat may be added into MIROBILD AC 3720 undercoat. This improves coverage and reduces waste

Colour : White & Colours as requested
Finish : Satin (30%), Semi Gloss (60%) & Full Gloss
Build : Excellent
Sandability : Excellent
Vertical Hold Up : Excellent
Solvent Resistance : Excellent
Water Resistance : Excellent
Levelling & Flow : Excellent
Sink Back : Minimal
Coverage : 6-7m2 per litre at 150 micron wet film build. This is dependent on the application equipment / gun set up and the article being coated
Dry Time : Refer to Technical Data Sheet
Clean Up : Clean all equipment using MIROSOL 1215 Thinner
Packaging : 1, 4, 20L
 

Data Sheet

Safety Data Sheets

Mixing Ratio (by volume) : Refer to Technical Data Sheet.
Pot Life : 1 - 2 days art 25°C (Refer to Technica Datasheet).
Thinning : Thin up to 25% with MIROSOL 1294 (Medium Thinner) - (Refer to Technica Datasheet).

Suction Gun - Use 1.5 to 2mm (59-79 thou) orifice with 350-400kpa (50-55 psi).
Pressure Pot - Use 1.5 to 2mm (59-79 thou) orifice with pressure pot air-cap. Gun pressure 350-400kpa (50-55 psi) and a pot pressure of 45kpa (6 psi) max.
Airless Spray - Use 0.23 to 0.33mm (9-13 thou) orifice, 15cm fan (dependent on job) with regulated pump pressure of 350-400kpa (50-55 psi).
Air Mix Guns - Settings similar to airless spray with the air-assisted regulator pressure at 70-90kpa (10-15psi).

Interior use. Domestic & commercial furniture, wardrobes, kitchen cupboards and doors.