MIROPOL PE 5007 High Gloss Clear Topcoat

• High Build
• Very High Gloss
• MIROPOL 5007 Clear can be applied to both natural timber substrates or foil covered MDF board. For interior use only.

Colour : Clear
Finish : Full Gloss
Build : Excellent
Sandability : Good
Vertical Hold Up : Good
Solvent Resistance : Excellent
Water Resistance : Excellent
Levelling & Flow : Excellent
Sink Back : Minimal
Coverage : 8m2 per litre at 100-150 micron wet film build. This is dependent on the application equipment / gun set up and the article being coated
Dry Time : Refer to Technical Data Sheet
Clean Up : Clean all equipment using MIROSOL 1215 Thinner
Packaging : 20L

Data Sheet

Safety Data Sheets

Mixing Ratio (by volume) : Mix 1 part by volume MIROPOL 5007 Clear Topcoat to 1 part by volume MIROPOL 5007 "B" Solution and stir thoroughly.
Pot Life : 2-3 hours (mix only samll quantities at any one time).
Thinning : Not required as MIROPOL 5007 Clear us supplied ready for ysue (RFU). If required use MIROSOL 1234 Ultra Fast Thinner sparingly.
 

Suction Gun - Use 1.5 to 2mm (59-79 thou) orifice with 350-400kpa (50-55 psi).
Pressure Pot - Use 1.5 to 2mm (59-79 thou) orifice with pressure pot air-cap. Gun pressure 350-400kpa (50-55 psi) and a pot pressure of 45kpa (6 psi) max.
Airless Spray - Use 0.23 to 0.33mm (9-13 thou) orifice, 15cm fan (dependent on job) with regulated pump pressure of 350-400kpa (50-55 psi).
Air Mix Guns - Settings similar to airless spray with the air-assisted regulator pressure at 70-90kpa (10-15psi).

Interior use. Solid and veneer timber fixtures and furniture. Restaurant, bar, and hotel furniture. Piano's. Funeral caskets and shop fittings.