MIROTHANE PU 5535 Clear Sealer

• Fast drying and easy sanding
• Excellent flow & levelling
• Highlights the grain and colour of Rimu
• Can be used under any Mirotone clear topcoat

Build: Very Good

Sandability: Very Good

Vertical Hold Up: Excellent

Solvent Resistance: Very Good

Water Resistance: Excellent

Levelling & Flow: Excellent

Sink Back: Minimal

Colour: Milky in-can dries clear

Data Sheet

Safety Data Sheets

Mixing Ratio: 2 Parts 5535 Part A + 1 Part 5730 Part B

Pot Life: 3-4 hours at 25ºC   (Pot life varies significantly with ambient temperature, humidity and the quantity mixed. Pot life is longer at lower temperatures and shorter at higher temperatures. The larger the quantity mixed, the shorter the pot life will be. Only mix the quantity required for the job.

Thinning: Not normally required but can be thinned up to 5% with MIROSOL 1217 Fast Thinner if required.

Suction Gun: Use 1.5 to 2mm (59-79 thou) orifice with 350-400kpa (50-55 psi).

Pressure Pot: Use 1.5 to 2mm (59-79 thou) orifice with pressure pot air-cap. Gun pressure 350-400 kpa (50-55 psi) and a pot pressure of 45 kpa (6psi) max.

Airless Spray - Use 0.23 to 0.33 (9-13 thou) orifice, 15cm fan (dependent on job) with regulated pump pressure of 350-400 kpa (50-55 psi).

Air Mix Guns - Settings similar to airless spray with the air-assisted regulator pressure at 70-90 kpa (10-15psi).

Interior use only for example solid and veneer timber fixtures and furniture including restaurant, bar and hotel furniture, pianos and caskets.