MIROTHANE PU 5608 Pigmented Topcoat

• Excellent flow, high build and quick drying
• Economical, cost effective furniture grade polyurethane

Colour : White, full colour range
Finish : Matt (10%), Satin (30%) & Semi-Gloss (60%)
Build : Very Good
Sandability : Very Good
Vertical Hold Up : Excellent
Solvent Resistance : Very Good
Water Resistance : Very Good
Levelling & Flow : Excellent
Sink Back : Minimal
Coverage : 6-7m2 per litre at 150 micron wet film build. This is dependent on the application equipment / gun set up and the article being coated
Dry Time : Refer to Technical Data Sheet
Clean Up : Clean all equipment using MIROSOL 1215 or 1217 Thinner
Packaging : 1, 4 & 16L

Data Sheet

Safety Data Sheets

Mixing Ratio (by volume) : Refer to Technical Data Sheet.
Pot Life : 6-8 hours at 25°C (Refer to Technical Datas Sheet).
Thinning : Thin 20-40% with MIROSOL 1280 (fast), 1265 (medium), 1266 (Slow)

Suction Gun - Use 1.5 to 2mm (59-79 thou) orifice with 350-400kpa (50-55 psi).
Pressure Pot - Use 1.5 to 2mm (59-79 thou) orifice with pressure pot air-cap. Gun pressure 350-400kpa (50-55 psi) and a pot pressure of 45kpa (6 psi) max.
Airless Spray - Use 0.23 to 0.33mm (9-13 thou) orifice, 15cm fan (dependent on job) with regulated pump pressure of 350-400kpa (50-55 psi).
Air Mix Guns - Settings similar to airless spray with the air-assisted regulator pressure at 70-90kpa (10-15psi).

Interior use only. Domestic furniture, commercial joinery, kitchen and bathroom cabinetry.